Spring is in the Air - Week 12

I love spring!  The new flowers starting to bloom and trees starting to bud make me wish I had a "green thumb", but I don't.  I can't seem to keep any plants alive, maybe it's because I forget to water the poor things!  This week I thought I would make a flower necklace to celebrate the first week of spring (no watering necessary).

 As usual, I gathered all the supplies I might need.  Molds, clay, cookie cutters and tools.

 I started with two shades of green and a white and kneaded different amounts of each together to make some pretty shades of green for the leaves.

 

 I pressed balls of clay into the mold.  The mold is made for working with cake fondant so it is a flexible silicon and the clay popped right out!  I trimmed the edges to neaten the leaves up.

 I repeated the same steps with all the clay colors and then baked the pieces in a 275 degree oven for 15 minutes.

 To make the clay look more like jewelry, I used gold and patina colored guilder's paste to give the pieces some interest.

 I also added some turqoise glitter and clear embossing powder and put them back in the oven for 2 minutes.  The heat made the embossing powder melt into a clear glaze.

 I assembled all the pieces together in a pleasing arrangement and then used hot glue to make them stick.  I added chain and a clasp to complete the necklace.  I think it turned out pretty gorgeous and I can't wait to wear it out!

A close-up look, I love how the green leaves and the bird look so vintage.

It's Good To Be Back - Weeks 10/11

I'm baaaaaccckkk!  I am feeling much better and ready to work!  For this project I wanted to do something a little more time consuming to make up for not doing a craft while I was sick!  I decided to make a quilted purse and matching zippered pouch.  So, here we go......

I started by gathering the supplies I thought I would need.  I also sketched a picture of the bag I wanted to make.  The roll of fabric strips was my inspiration.  It is a roll of pre-cut 2 1/2 inch strips in a palette of red, white, and blue.  

I chose the strip colors I wanted to work with and started sewing them together using a 1/4 inch seam allowance.

After sewing all the strips together I ironed the piece flat.

I then cut the large panel of strips into two smaller pieces to use as the front and back of the purse. I also did this with the lining fabric.

I cut two matching panels of a medium weight batting and started to quilt the fabric to the batting.  I decided to sew a top stitch 1/4 inch away from the seam of each piece to make a clean simple line.

Next, to give the bag a little shape, I sewed a pleat into the front and back center of the bag and lining.

The supplies for the flap.  I sewed two pieces of the fabric together and attached one part of the magnetic snap to the flap and the other half to the front of the bag.

I sewed the front and back of the purse pieces together at the sides and bottom.  To create some depth to the purse I "bagged" the bottom by matching the bottom and side seams and sewing across 2 inches from the edge.

With right sides together I inserted the bag into the lining and sewed around the top edge.

I left an opening in the bottom seam of the lining and pulled the bag through it.  I sewed the seam closed and tucked the lining into the bag.

I sewed around the top of the bag again to make sure the lining stayed tucked in.

I made straps by sewing two long strips right sides together and then turned them right side out.  I attached them to the sides of the bag, leaving some hanging down on both sides to tie into a knot.

The finished purse with the side knots and the flap closed!

A close-up.

To make the pouch I cut two smaller pieces of my fabric strip set and attached a zipper to the top of each piece before I sewed the sides and bottom.  

The finished set!  I love how these turned out and I am sure I will use them a lot!  Hope you like enjoyed seeing my creative process!

A Busy Week - Week 9

This week has been a busy week!  Not only did I make the dress you will see in the blog, but I helped out at Wyatt's school and helped his teacher finish a cute project that I will also show you!  Then, Wyatt came down with the flu on Thursday and unfortunately, I think it's coming my way too!  Whew...here we go!  The pattern I chose is Simplicity 2590 and I made view D, that was inspired by view B.  That's what I  love about sewing, changing things up and making them your own.

View D is a halter style dress, but I made it out of two fabrics like view B.  The fabrics are pre-washed 100% cotton.  One is a black and white polka dot print, the other is a black white and red floral/Asian print.

Cutting out the pieces, there were only four!  Bodice front and back and skirt front and back!

Since the dress is a halter the armhole edges need to be finished.  The directions called for sewing seam binding to the right side of the fabric and folding to the inside and sewing close to the edge.  This turned out really nice!

Oops...it wouldn't be a Stephanie project if I didn't have to rip out some threads!  I was supposed to sew the side seams together with the right sides of the fabric facing each other.  Instead I had right side to wrong side!  

The finished dress is a little different than the pattern...I placed the elastic at the seam between the two fabrics because I am longer waisted than the pattern and where it wanted me to put the elastic would have put it almost under my chest!  Not a good look!  The top tie is a red grosgrain ribbon and I plan to wear this with a red patent leather belt.  This was a fun and easy dress to make!

The project I helped out with for Wyatt's teacher was really clever.

The kids painted and decorated these pages to look like Washington and Lincoln.

I cut them all out and glued them together back to back matching the shapes.

Then, when you flip it over one side is Washington and the other is Lincoln!  Pretty cute!  Wyatt's teacher comes up with some really great crafts for them and I am always happy to help her out!